December 2016 - Ibr-dtn - lists.ibr.cs.tu-bs.de

IBR-DTN : development tools
by Leonel Gaspar Soares 30 Dec '16

30 Dec '16

Hello, I'm new in DTN use and after reading the advantages of IBR-DNT in OpenWrt, I became interested in developing some application for file transfer in my MsC Thesis in Electrical Engineering. However, after reading the wiki, I still don't understand very well the packages that I must install or how can budle encapsulation is made. Where can I find such information? Thank you very much. Leonel Soares

2 1

dtninbox quiet option
by Dominic Solpico 13 Dec '16

13 Dec '16

Hello. When I executed dtninbox --quiet <name> <inbox> in my Raspberry Pi, I get the message "Aborted." It is not working. I used the --quiet option for dtnoutbox and it worked properly. What could be the problem with dtninbox? I am attaching the configuration file that I used. Thanks.

1 0

Ibr-dtn Warning message
by chaitra vijendra 09 Dec '16

09 Dec '16

Hello, I downloaded ibr-dtn implementation for Ubuntu 14.04 and installed it on two PCs with similar configuration. I am running dtnsend on one pc and dtnrecv on another. The bundles are accepted and the file reaches the dtnrecv. Later I run the dtnsend on the PC which was running dtnrecv and dtnrecv on the PC which was running dtnsend, I am getting Warning "*bundle rejected due to invalid authentication*" on the PC that is running dtnrecv. Can u plz help me what could be the problem or should I do any other change for the dtnrecv to accept packets. Thanks in advance -- Chaitra

1 0

WARNING BundleFilter: bundle rejected due to invalid authentication
by gutelfuldead . 05 Dec '16

05 Dec '16

When using: *$ dtnping dtn://zed1/echo* dtnd returns the following error before the echo times out: *WARNING BundleFilter: bundle rejected due to invalid authenticati**on ([0.233726701] dtn://zed0/aSreNqipcPcrKVmE)* Where zed0 is the pinging host device. The setup is two ZedBoards connected via an ethernet switch on the same subnet. Attached is my ibrdtn.conf file which is identical between the two devices with the only difference being the local node name which is zed0 or zed1. I tried explicitly setting the * security_level = 0* as well to the same effect. Thanks.

1 0